国产在线精品亚洲一区二区三区

  • <th id="h0jh4"></th>
  • <big id="h0jh4"></big><code id="h0jh4"></code>
    <code id="h0jh4"><em id="h0jh4"></em></code>
    歡迎光臨!濟南聯眾供熱設備廠,主營:山東燃氣鍋爐,山東電采暖鍋爐,山東多介質過濾器和射線防護器材等。
  • 服務熱線:18678809986
  • 首頁 關于我們 產品中心 新聞中心 工程案例 設備選型 聯系我們
  • 您的位置:首頁> 新聞中心 >

    天然氣鍋爐燃燒器開機操作流程
    來源:http://www.inifakta.com 發布時間:2020-12-10

    1.對新安裝爐體,調試前應認真檢測燃氣是否符合燃燒器的要求;檢查供氣管路上的檢測儀器是否正常及管道閥門開、關是否正常,是否便于以后使用及檢修。
    1. For the newly installed furnace body, before commissioning, carefully check whether the gas meets the requirements of the burner; check whether the detection instruments on the gas supply pipeline are normal and whether the opening and closing of the pipeline valves are normal, and whether it is convenient for future use and maintenance.
    2.對新安裝的管道,應認真檢查所有管路的安裝可靠性和管路的密封性。
    2. For newly installed pipelines, the installation reliability and sealing of all pipelines shall be carefully checked.
    3.使用單獨氣化站的用戶,要保證供氣量、供氣參數符合安全燃燒要求。
    3. Users who use separate gasification station should ensure that the gas supply quantity and gas supply parameters meet the requirements of safe combustion.
    4.操作人員認真閱讀設備使用說明書,熟練掌握安全操作知識及方法。
    4. Operators carefully read the equipment operation manual and master the knowledge and methods of safe operation.
    5.天然氣鍋爐燃燒器每次開機前要檢查燃氣閥門是否打開,否則燃燒器不工作。
    5. Check whether the gas valve is open before starting the burner of natural gas boiler, otherwise the burner will not work.
    6.啟動控制柜上的電源控制按扭,此時數顯表就顯示當前爐內溫度,新安的裝爐體此溫度為環境溫度。
    6. Start the power control button on the control cabinet. At this time, the digital display will display the current temperature in the furnace. This temperature of Xinan furnace charging body is the ambient temperature.
    7.啟動風機控制按扭,安裝在爐體上的風機就工作,此時若風機損壞控制柜就自動保護不進入下一步操作。
    7. Start the fan control button, and the fan installed on the furnace body will work. At this time, if the fan is damaged, the control cabinet will be automatically protected from further operation.
    8.助燃風機工作無異?,F象時,再啟動燃燒控制按扭,此時燃燒程序控制器就開始工作,它通過一定的程序進行點火、送氣、檢測火焰、等程序更終實現安全燃燒。
     山東燃氣鍋爐
    8. When there is no abnormal phenomenon in the combustion fan, the combustion control button will be started again. At this time, the combustion program controller will start to work. It will carry out ignition, air supply, flame detection and other procedures through certain procedures, and finally realize safe combustion.
    9.天然氣鍋爐燃燒器當燃燒控制器收到不利于燃燒的信號(例:點火失敗、氣壓不穩定、電路有問題)等問題時,燃燒控制器就立刻關閉燃氣并發出報警信號。
    9. When the combustion controller receives the signal that is not conducive to combustion (e.g. ignition failure, air pressure instability, circuit problems) and other problems, the combustion controller will immediately shut down the gas and send out an alarm signal.
    10.燃燒控制器若報警,必須是解決故障后由操作人員對其手動復位才可以繼續工作。
    10. If the combustion controller gives an alarm, it must be reset manually by the operator after the fault is solved.
    11.整個設備的操作,操作人員應參考爐體安全操作規程及生產工藝要求進行操作。
    11. For the operation of the whole equipment, the operators should refer to the furnace safety operation regulations and production process requirements.
    12.按生產工藝要求需要調整控制溫度時,操作員應參考智能數控表說明書進行調節。
    12. When the control temperature needs to be adjusted according to the production process requirements, the operator should refer to the manual of intelligent numerical control table for adjustment.
    (二) 天然氣鍋爐燃燒器關機操作
    (2) Shutdown operation of natural gas boiler burner
    (1)關機有兩種情況:是:當爐內溫度到達所設定值自動關機,此時操作員不必任何操作,等到爐內溫度低于設定值時控制器會自動開機。
    (1) There are two cases of shutdown: the first is: when the furnace temperature reaches the set value, the operator does not need any operation, and the controller will automatically start up when the furnace temperature is lower than the set value.
    (2)第二是:人為停機和交接班停機時,此時操作員應按開機時的相反順序(a.先關閉燃燒控制按扭、b.再關閉風機按扭、c.關閉電源按扭)操作關機。
    (2) The second is: in case of man-made shutdown and shift change shutdown, the operator should operate and shut down in the reverse order (A. first turn off the combustion control button, B. then turn off the fan button, C. finally turn off the power button).
    (3)天然氣鍋爐燃燒器關機時間較長情況下操作員應關閉燃氣管路閥門,以免燃氣泄漏現象發生。括和常識考查。內容概括摘原文,常識考查適當須積累文學、文化常識。
    (3) When the burner of natural gas boiler is shut down for a long time, the operator should close the gas pipeline valve to avoid gas leakage. General knowledge examination. It is necessary to accumulate common knowledge of literature and culture.

    魯公網安備 37011302000227號

    国产在线精品亚洲一区二区三区
  • <th id="h0jh4"></th>
  • <big id="h0jh4"></big><code id="h0jh4"></code>
    <code id="h0jh4"><em id="h0jh4"></em></code>